Energy from Fuels (HL IB Chemistry)

Isooctane, which is added to petrol to increase the octane rating, burns smoothly in a car engine. It is a branched chain isomer of octane, with the skeletal formula shown below. 

In the high temperatures in a car engine with the presence of oxygen, alkanes undergo combustion to release heat energy.

The structures of three alkanes are given.

Write an equation for the complete combustion of isooctane.

The toxic gas carbon monoxide can be produced during incomplete combustion.

Explain why carbon monoxide is dangerous if inhaled.

A diesel fuel containing the hydrocarbon tetradecane, C₁₄H₃₀, burns with a sooty yellow flame. 

Write a balanced symbol equation, including state symbols, for the reaction described.

Fuel cells are used to generate an electric current and do not need to be electrically recharged. The Gemini and Apollo moon probes use hydrogen-oxygen fuel cells. The product of this reaction can be used to supplement the drinking water for astronauts.

Deduce the half equations for the reactions at each electrode in a hydrogen oxygen fuel cell, and then the overall equation for the hydrogen-oxygen fuel cell, to show the product used to supplement drinking water.

A fuel cell is an electrochemical device which converts chemical energy into electrical energy. A continuous supply of fuel is supplied to one electrode and an oxidant to the other. 

The electrodes used in hydrogen fuel cells are often made of a porous mixture of carbon-supported platinum or a porous ceramic material coated in platinum. 

State why the electrodes must be porous.

The General Motors Electrovan was built in 1966. It was the first vehicle powered by a hydrogen fuel cell and could travel at up to 70 mph for 30 seconds.

Vegetable oils are often reacted with methanol in the manufacture of biodiesel.

Write the equation for the reaction of the vegetable oil with methanol.

State two advantages and two differences associated with the use of biodiesel

A student carried out a calorimetry experiment to determine the enthalpy of combustion of a sample of biodiesel.

5.0 cm³ of biodiesel (density = 0.780 g cm^–3) was introduced into an open flame calorimeter containing 1 dm³ of water at 20.0 °C. The final temperature of the water was recorded at 55 °C. 

10 cm³ of a gaseous hydrocarbon, C_xH_y, was reacted with 100 cm³ of oxygen gas. The final volume of the gaseous mixture was 95 cm³. This gaseous mixture was treated with concentrated, aqueous sodium hydroxide to absorb the carbon dioxide present. This reduced the gas volume to 75 cm³.

All gas volumes were measured at 298 K and 100 kPa.

Write an equation for the reaction between sodium hydroxide and carbon dioxide.

Use the information in (a) to balance the equation below.

............C_xH_y + ............O₂ → ............CO₂ + zH₂O

Deduce the values of x, y and z in the equation in (b).

Climate change, with a focus on carbon dioxide emissions, is a continuing global topic of debate.

The following graph shows the annual increase in the concentration of atmospheric carbon dioxide recorded at Mauna Loa, Hawaii.

Explain why the graph is not smooth.

Explain the molecular mechanism of greenhouse gases, in relation to carbon dioxide.

Gases other than carbon dioxide are known to cause global warming and climate change. Discuss the significance of two of these greenhouse gases.

Although they are finite, fossil fuels are considered significant sources of energy. Using fossil fuels for electricity production is a very inefficient process with the total possible energy conversion typically around 40%.

Fuel cells are more efficient, often with a 70% conversion.

State the energy change conversion that occurs in fossil fuels and fuel cells.

One type of fuel cell contains a proton exchange membrane between electrodes and uses aqueous methanol as the fuel.

Deduce the half-equations and the overall equation for the reactions taking place, under acidic conditions, in this fuel cell.

Negative electrode: 

........................................................................................................................

Positive electrode:

........................................................................................................................

Overall equation: 

........................................................................................................................